Datasheet Texas Instruments 74ACT16474DLR — Ficha de datos

FabricanteTexas Instruments
Serie74ACT16474
Numero de parte74ACT16474DLR

Transceptores de bus registrados de 18 bits con salidas de 3 estados 56-SSOP -40 a 85

Hojas de datos

18-Bit Registered Bus Transceivers With 3-State Outputs (Rev. A)
PDF, 136 Kb, Revisión: A, Archivo publicado: abr 1, 1996

Precios

Estado

Estado del ciclo de vidaObsoleto (El fabricante ha interrumpido la producción del dispositivo)
Disponibilidad de muestra del fabricanteNo

Embalaje

Pin56
Package TypeDL
Industry STD TermSSOP
JEDEC CodeR-PDSO-G
Width (mm)7.49
Length (mm)18.41
Thickness (mm)2.59
Pitch (mm).635
Max Height (mm)2.79
Mechanical DataDescargar

Plan ecológico

RoHSDesobediente
Pb gratisNo

Notas de aplicación

  • Selecting the Right Level Translation Solution (Rev. A)
    PDF, 313 Kb, Revisión: A, Archivo publicado: jun 22, 2004
    Supply voltages continue to migrate to lower nodes to support today's low-power high-performance applications. While some devices are capable of running at lower supply nodes others might not have this capability. To haveswitching compatibility between these devices the output of each driver must be compliant with the input of the receiver that it is driving. There are several level-translati
  • Implications of Slow or Floating CMOS Inputs (Rev. D)
    PDF, 260 Kb, Revisión: D, Archivo publicado: jun 23, 2016
  • TI IBIS File Creation Validation and Distribution Processes
    PDF, 380 Kb, Archivo publicado: agosto 29, 2002
    The Input/Output Buffer Information Specification (IBIS) also known as ANSI/EIA-656 has become widely accepted among electronic design automation (EDA) vendors semiconductor vendors and system designers as the format for digital electrical interface data. Because IBIS models do not reveal proprietary internal processes or architectural information semiconductor vendors? support for IBIS con
  • CMOS Power Consumption and CPD Calculation (Rev. B)
    PDF, 89 Kb, Revisión: B, Archivo publicado: jun 1, 1997
    Reduction of power consumption makes a device more reliable. The need for devices that consume a minimum amount of power was a major driving force behind the development of CMOS technologies. As a result CMOS devices are best known for low power consumption. However for minimizing the power requirements of a board or a system simply knowing that CMOS devices may use less power than equivale
  • Designing With Logic (Rev. C)
    PDF, 186 Kb, Revisión: C, Archivo publicado: jun 1, 1997
    Data sheets which usually give information on device behavior only under recommended operating conditions may only partially answer engineering questions that arise during the development of systems using logic devices. However information is frequently needed regarding the behavior of the device outside the conditions in the data sheet. Such questions might be:?How does a bus driver behave w
  • Using High Speed CMOS and Advanced CMOS in Systems With Multiple Vcc
    PDF, 43 Kb, Archivo publicado: abr 1, 1996
    Though low power consumption is a feature of CMOS devices sometimes this feature does not meet a designer?s system power supply constraints. Therefore a partial system power down or multiple Vcc supplies are used to meet the needs of the system. This document shows electrostatic discharge protection circuits. It also provides circuit and bus driver examples of partial system power down and curren

Linea modelo

Serie: 74ACT16474 (2)

Clasificación del fabricante

  • Semiconductors > Logic > Buffer/Driver/Transceiver > Registered Transceiver