Datasheet Texas Instruments UCC2817N — Ficha de datos

FabricanteTexas Instruments
SerieUCC2817
Numero de parteUCC2817N
Datasheet Texas Instruments UCC2817N

Preregulador de factor de potencia BiCMOS 16-PDIP -40 a 85

Hojas de datos

UCC2817, UCC2818, UCC3817 and UCC3818 BiCMOS Power Factor Pregulator datasheet
PDF, 1.4 Mb, Revisión: K, Archivo publicado: oct 1, 2016
Extracto del documento

Estado

Estado del ciclo de vidaActivo (Recomendado para nuevos diseños)
Disponibilidad de muestra del fabricanteNo

Embalaje

Pin16
Package TypeN
Industry STD TermPDIP
JEDEC CodeR-PDIP-T
Package QTY25
CarrierTUBE
Device MarkingUCC2817N
Width (mm)6.35
Length (mm)19.3
Thickness (mm)3.9
Pitch (mm)2.54
Max Height (mm)5.08
Mechanical DataDescargar

Paramétricos

Control MethodCCM
Device TypeSingle-phase PFC
Operating Supply Current4 mA
Operating Supply(Max)18 V
Operating Temperature Range-40 to 85 C
Package GroupPDIP
Package Size: mm2:W x LSee datasheet (PDIP) PKG
Peak Output Sink Current Gate Drive1.2 A
Peak Output Source Current Gate Drive-1.2 A
Practical Operating Frequency(Max)0.25 MHz
RatingCatalog
Special Features< 150W Applications,> 750W Applications,Average Current Mode,Enable,OVP
Startup Current0.15 mA
UVLO Thresholds On/Off16/10 V

Plan ecológico

RoHSObediente

Kits de diseño y Módulos de evaluación

  • Evaluation Modules & Boards: UCC3817EVM
    UCC3817EVM BiCMOS Power Factor Preregulator EVM
    Estado del ciclo de vida: Activo (Recomendado para nuevos diseños)

Notas de aplicación

  • PFC Family Differences UCC3817A/18A/19A and UCC3817/18/19
    PDF, 32 Kb, Archivo publicado: agosto 18, 2003
    The UCC3817A/18A/19A family of PFC controllers (UCC3817A family) is pin for pin compatible with the UCC3817/18/19 family of devices (UCC3817 family). The output stage of UCC3817A family has been updated to allow use of a smaller external gate drive resistor values. For some power supply designs where an adequately high enough gate drive resistor can not be used, the UCC3817A family offers a more r
  • UCC3817 Current Sense Transformer Evaluation
    PDF, 49 Kb, Archivo publicado: feb 13, 2004
  • Synchronizing a PFC Controller from a Down Stream Controller Gate Drive
    PDF, 103 Kb, Archivo publicado: nov 3, 2000
    Due to pending line harmonic requirements at higher power levels, power factor correction (PFC) is required in some ac-to-dc off-line power converter applications. This type of power converter can be designed with two cascaded power stages similar to the configuration in Figure 1. The first stage is a boost converter that converts the ac voltage to dc voltage with PFC. The output voltage of the bo
  • Bootstrap Circuit for Green Mode Applications
    PDF, 111 Kb, Archivo publicado: enero 27, 2006
  • AC Requirements for Power Factor Correction Circuits
    PDF, 29 Kb, Archivo publicado: marzo 28, 2002
    This technical brief identifies the recommended range of IAC for each of the devices within the UCC3854 family of PFC controllers.
  • Startup Current transient of the Leading Edge Triggered PFC Controllers
    PDF, 43 Kb, Archivo publicado: jun 30, 2004
  • Avoiding Audible Noise at Light Loads When Using Leading Edge Triggered PFC Con (Rev. C)
    PDF, 57 Kb, Revisión: C, Archivo publicado: abr 13, 2011
    This application note applies to the TI average current mode, leading edge modulation PFC controllers. See Applicable Device Table for part numbers.
  • DN-66 UC3854A/B and UC3855A/B Provide Power Limiting with Sinusoidal Input (Rev. A)
    PDF, 80 Kb, Revisión: A, Archivo publicado: nov 6, 2001
  • Accurate PWM Duty Cycle Clamp
    PDF, 58 Kb, Archivo publicado: enero 25, 2002
    Power supply applications using current sense transformers require a duty cycle clamp on the pulse width modulator (PWM) to ensure transformer reset. Not all PWMs come with a duty cycle clamp presenting a problem for the power supply designer. This application note shows how to implement a duty cycle clamp by using a simple delay circuit.

Linea modelo

Clasificación del fabricante

  • Semiconductors > Power Management > Offline and Isolated DC/DC Controllers and Converters > Power Factor Correction