Datasheet Texas Instruments TPS61029DRCR — Ficha de datos

FabricanteTexas Instruments
SerieTPS61029
Numero de parteTPS61029DRCR
Datasheet Texas Instruments TPS61029DRCR

Ajustable, conmutador 1.8-A, convertidor de refuerzo eficiente al 96% con modo inactivo, QFN-10 10-VSON -40 a 85

Hojas de datos

TPS6102x 96% Efficient Synchronous Boost Converter datasheet
PDF, 1.2 Mb, Revisión: G, Archivo publicado: dic 24, 2014
Extracto del documento

Precios

Estado

Estado del ciclo de vidaActivo (Recomendado para nuevos diseños)
Disponibilidad de muestra del fabricante

Embalaje

Pin10
Package TypeDRC
Industry STD TermVSON
JEDEC CodeS-PDSO-N
Package QTY3000
CarrierLARGE T&R
Device MarkingBRF
Width (mm)3
Length (mm)3
Thickness (mm).9
Pitch (mm).5
Max Height (mm)1
Mechanical DataDescargar

Paramétricos

Duty Cycle(Max)100 %
Iq(Typ)0.025 mA
Operating Temperature Range-40 to 85 C
Package GroupVSON
RatingCatalog
Regulated Outputs1
Special FeaturesEnable,Light Load Efficiency,Load Disconnect,Power Good
Switch Current Limit(Min)1.5 A
Switch Current Limit(Typ)1.8 A
Switching Frequency(Max)720 kHz
Switching Frequency(Min)480 kHz
TypeConverter
Vin(Max)5.5 V
Vin(Min)0.9 V
Vout(Max)5.5 V
Vout(Min)1.8 V

Plan ecológico

RoHSObediente

Kits de diseño y Módulos de evaluación

  • Evaluation Modules & Boards: TPL5111EVM
    TPL5111 Low Power System Timer Evaluation Module
    Estado del ciclo de vida: Activo (Recomendado para nuevos diseños)

Notas de aplicación

  • TPS6102x Boost Converter Down Conversion Mode
    PDF, 159 Kb, Archivo publicado: dic 16, 2004
    The TPS61020 is a highly integrated, low-power, boost converter ideally suited for portable battery-powered equipment. The integrated down conversion mode allows the boost converter to operate with the input voltage greater than the output voltage, which is normally only possible with more complicated converters.
  • Factors That Determine Light Load PSM Switch Freq for TPS6102x Boost Converters
    PDF, 528 Kb, Archivo publicado: abr 21, 2006
  • Five Steps to a Good PCB Layout of the Boost Converter
    PDF, 701 Kb, Archivo publicado: mayo 3, 2016
  • Minimizing Ringing at the Switch Node of a Boost Converter
    PDF, 201 Kb, Archivo publicado: sept 15, 2006
    The application report explains how to use proper board layout and/or a snubber to reduce high-frequency ringing at the switch node of a boost converter.
  • Design considerations for a resistive feedback divider in a DC/DC converter
    PDF, 393 Kb, Archivo publicado: abr 26, 2012
  • Basic Calculation of a Boost Converter's Power Stage (Rev. C)
    PDF, 186 Kb, Revisión: C, Archivo publicado: enero 8, 2014
    This application note gives the equations to calculate the power stage of a boost converter built with an IC with integrated switch and operating in continuous conduction mode. It is not intended to give details on the functionality of a boost converter (see Reference 1) or how to compensate a converter. See the references at the end of this document if more detail is needed.
  • Optimizing Transient Response of Internally Compensated DC-DC Converters (Rev. A)
    PDF, 1.1 Mb, Revisión: A, Archivo publicado: mayo 11, 2015
  • Extending the Soft Start Time Without a Soft Start Pin (Rev. B)
    PDF, 387 Kb, Revisión: B, Archivo publicado: jun 15, 2017
  • Choosing an Appropriate Pull-up/Pull-down Resistor for Open Drain Outputs
    PDF, 130 Kb, Archivo publicado: sept 19, 2011
  • QFN and SON PCB Attachment (Rev. B)
    PDF, 821 Kb, Revisión: B, Archivo publicado: agosto 24, 2018
  • IQ: What it is what it isn’t and how to use it
    PDF, 198 Kb, Archivo publicado: jun 17, 2011
  • Performing Accurate PFM Mode Efficiency Measurements (Rev. A)
    PDF, 418 Kb, Revisión: A, Archivo publicado: dic 11, 2018
    When performing measurements on DC-DC converters using pulse frequency modulation(PFM)or any power save mode proper care must be taken to ensure that the measurements are accurate. An accurate PFM mode efficiency measurement is critical for systems which require high efficiency at low loads such as in smart home systems tablets wearables and metering.

Linea modelo

Serie: TPS61029 (4)

Clasificación del fabricante

  • Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Up (Boost) > Boost Converter (Integrated Switch)