Datasheet Texas Instruments TPS60301DGSR — Ficha de datos

Single-Cell a 3.0V / 3.3V, 20mA de salida dual, bomba de carga de alta eficiencia 10-VSSOP -40 a 85

Hojas de datos

PDF, 1.3 Mb, Revisión: B, Archivo publicado: oct 30, 2015

Extracto del documento

Estado del ciclo de vida	Activo (Recomendado para nuevos diseños)
Disponibilidad de muestra del fabricante	Sí

Iout(Max)	0.04 A
Iq(Typ)	0.035 mA
Operating Temperature Range	-40 to 85 C
Package Group	VSSOP
Rating	Catalog
Regulated Outputs	2
Special Features	Enable,Power Good
Switching Frequency(Max)	650 kHz
Switching Frequency(Min)	470 kHz
Type	Charge Pump
Vin(Max)	1.8 V
Vin(Min)	0.9 V
Vout(Max)	3 V
Vout(Min)	3 V

RoHS

Obediente

Descargar
Improved Start-up Performance for Charge Pumps TPS6030x
PDF, 36 Kb, Archivo publicado: mayo 29, 2001
This document shows a solution to enhance the start-up performance of the TPS603x charge pumps. With the circuitry shown, the device can drive at start-up into full load (40 mA).
Descargar
Design considerations for a resistive feedback divider in a DC/DC converter
PDF, 393 Kb, Archivo publicado: abr 26, 2012
Descargar
Extending the Soft Start Time Without a Soft Start Pin (Rev. B)
PDF, 387 Kb, Revisión: B, Archivo publicado: jun 15, 2017
Descargar
Choosing an Appropriate Pull-up/Pull-down Resistor for Open Drain Outputs
PDF, 130 Kb, Archivo publicado: sept 19, 2011
Descargar
Performing Accurate PFM Mode Efficiency Measurements (Rev. A)
PDF, 418 Kb, Revisión: A, Archivo publicado: dic 11, 2018
When performing measurements on DC-DC converters using pulse frequency modulation(PFM)or any power save mode proper care must be taken to ensure that the measurements are accurate. An accurate PFM mode efficiency measurement is critical for systems which require high efficiency at low loads such as in smart home systems tablets wearables and metering.

Serie: TPS60301 (4)

Semiconductors > Power Management > Non-isolated DC/DC Switching Regulator > Step-Up (Boost) > Boost Charge Pump (Inductorless)