Datasheet Texas Instruments CC1101-Q1 — Ficha de datos

FabricanteTexas Instruments
SerieCC1101-Q1
Datasheet Texas Instruments CC1101-Q1

Transceptor RF de bajo costo y bajo consumo de energía a 1 GHz

Hojas de datos

Low-Power Sub-1-GHz Fractional-N UHF Device Family for Automotive datasheet
PDF, 1.6 Mb, Revisión: B, Archivo publicado: abr 16, 2010
Extracto del documento

Precios

Estado

CC1101QRHBRG4Q1
Estado del ciclo de vidaActivo (Recomendado para nuevos diseños)
Disponibilidad de muestra del fabricanteNo

Embalaje

CC1101QRHBRG4Q1
N1
Pin32
Package TypeRHB
Industry STD TermVQFN
JEDEC CodeS-PQFP-N
Package QTY3000
Device MarkingQQ1
Width (mm)5
Length (mm)5
Thickness (mm).9
Pitch (mm).5
Max Height (mm)1
Mechanical DataDescargar

Paramétricos

Parameters / ModelsCC1101QRHBRG4Q1
CC1101QRHBRG4Q1
Data Rate(Max), kbps250
Device TypeUHF Transceiver
Frequency Bands, MHz315,433,779,868,915,920
Operating Temperature Range, C-40 to 125
RX Current (Lowest), mA15.5
RatingAutomotive
Sensitivity (Best), dBm-114
Special FeaturesAEC-Q100 Grade 1/125В°C
TX Power(Max), dBm12
TechnologySub-1 GHz
Throughput(Max), Mbps0.6

Plan ecológico

CC1101QRHBRG4Q1
RoHSObediente

Notas de aplicación

  • DN013 -- Programming output powers on CC1101 (Rev. A)
    PDF, 238 Kb, Revisión: A, Archivo publicado: enero 2, 2008
  • DN010 -- Close-in Reception with CC1101 (Rev. B)
    PDF, 102 Kb, Revisión: B, Archivo publicado: jul 21, 2009
  • Resonant Trimming Sequence
    PDF, 88 Kb, Archivo publicado: enero 9, 2013
    This application report presents an efficient and precise method on how to achieve the desired resonant frequency of configuring the trim array with only a few iterations and measuring the resonant frequency. First, the minimum and maximum resonant frequency is measured; from this data a capacitance gradient is derived, which allows a good prediction of the required capacitance. The calculated cap
  • DN017 -- CC11xx 868/915 MHz RF Matching (Rev. A)
    PDF, 328 Kb, Revisión: A, Archivo publicado: marzo 31, 2008
    There are three versions of the CC11xx reference design which have been published. This design note gives a short introduction to RF matching and important aspects when designing products using the CC11xx parts and discusses the differences between the three reference design revisions.
  • AN072 -- Using the TAI-SAW TA0801A SAW Filter and External PA (Rev. A)
    PDF, 359 Kb, Revisión: A, Archivo publicado: agosto 19, 2009
  • AN050 -- Using the CC1101 in the European 868MHz SRD band (Rev. B)
    PDF, 223 Kb, Revisión: B, Archivo publicado: sept 11, 2009
  • DN501 -- PATABLE Access (Rev. B)
    PDF, 66 Kb, Revisión: B, Archivo publicado: marzo 24, 2009
  • DN500 -- Packet Transmission Basics (Rev. C)
    PDF, 174 Kb, Revisión: C, Archivo publicado: abr 6, 2009
  • DN503 -- SPI Access (Rev. B)
    PDF, 94 Kb, Revisión: B, Archivo publicado: oct 22, 2007
    The purpose of this design note is to show how the serial peripheral interface (SPI) must be configured to be able to communicate with the CC1100/CC1101/CC1150/CC2500/CC2550. It also shows how the status bytes should be interpreted and how SW reset is done over the SPI interface.
  • DN111 - Current Consumption for a Polling Receiver (Rev. A)
    PDF, 687 Kb, Revisión: A, Archivo publicado: marzo 24, 2009
  • DN505 -- RSSI interpretation and timing (Rev. D)
    PDF, 129 Kb, Revisión: D, Archivo publicado: jun 16, 2010
  • DN506 -- GDO Pin Usage (Rev. A)
    PDF, 219 Kb, Revisión: A, Archivo publicado: oct 22, 2007
    The purpose of this design note is to explain how to use the different general digital output (GDO) pins for control and monitoring purposes. The focus is set on interfacing with a microcontroller unit (MCU) and is related to the CC1100, CC1101, CC1150, CC2500 and CC2550 devices.
  • DN005 -- CC11xx Sensitivity versus Frequency Offset and Crystal Accuracy (Rev. C)
    PDF, 96 Kb, Revisión: C, Archivo publicado: agosto 20, 2009
  • DN022 -- CC110x CC111x OOK ASK Register Settings (Rev. E)
    PDF, 532 Kb, Revisión: E, Archivo publicado: marzo 8, 2012
  • DN504 -- FEC Implementation (Rev. A)
    PDF, 110 Kb, Revisión: A, Archivo publicado: oct 22, 2007
    This design note explains the functionality of forward error correction (FEC) and how it is used in the CC1100, CC1101, CC1110, CC1111, CC1150, CC2500, CC2510, CC2511, and CC2550 devices. Example code for FEC implementation is included.
  • DN016 -- Compact Antenna Solution for 868/915 MHz (Rev. B)
    PDF, 832 Kb, Revisión: B, Archivo publicado: agosto 20, 2009
  • DN502 -- CRC Implementation (Rev. D)
    PDF, 55 Kb, Revisión: D, Archivo publicado: oct 27, 2009
  • DN024 -- 868 MHz, 915 MHz and 955 MHz Monopole PCB Antenna (Rev. E)
    PDF, 1.0 Mb, Revisión: E, Archivo publicado: feb 22, 2013
  • DN033 - Mitsubishi Ceramic Antenna for 868 MHz, 915 MHz & 955 (Rev. A)
    PDF, 685 Kb, Revisión: A, Archivo publicado: sept 14, 2010
  • DN023 -- 868 MHz, 915 MHz and 955 MHz Inverted F Antenna (Rev. C)
    PDF, 369 Kb, Revisión: C, Archivo publicado: agosto 30, 2011

Linea modelo

Serie: CC1101-Q1 (1)

Clasificación del fabricante

  • Semiconductors> Wireless Connectivity> Companion Wireless Solutions> Smart RF Transceivers