DATASHEET
ISL22346 FN6177
Rev 2.00
September 3, 2009 Quad Digitally Controlled Potentiometers (XDCPв„ў) Low Noise, Low Power I2Cв„ў
Bus, 128 Taps
The ISL22346 integrates four digitally controlled potentiometers
(DCP) and non-volatile memory on a monolithic CMOS
integrated circuit.
The digitally controlled potentiometers are implemented with
a combination of resistor elements and CMOS switches. The
position of the wipers are controlled by the user through the
I2C bus interface. Each potentiometer has an associated
volatile Wiper Register (WR) and a non-volatile Initial Value
Register (IVR) that can be directly written to and read by the
user. The contents of the WR controls the position of the
wiper. At power-up the device recalls the contents of the two
DCP’s IVR to the corresponding WRs.
The DCPs can be used as a three-terminal potentiometers
or as a two-terminal variable resistors in a wide variety of
applications including control, parameter adjustments, and
signal processing. Features Four potentiometers in one package 128 resistor taps I2C serial interface
-Three address pins, up to eight devices/bus Non-volatile storage of wiper position Wiper resistance: 70пЃ— typical @ VCC = 3.3V Shutdown mode Shutdown current 5ВµA max Power supply: 2.7V to 5.5V 50kпЃ—пЂ or 10kпЃ— total resistance High reliability
-Endurance: 1,000,000 data changes per bit per register …