Datasheet Intersil HS1-26C32RH-T — Ficha de datos

DATASHEET
HS-26C32RH-T FN4592
Rev 2.00
August 1, 2008 Radiation Hardened Quad Differential Line Receiver
Intersil’s Satellite Applications Flow™ (SAF) devices are fully
tested and guaranteed to 100kRAD total dose. These QML
Class T devices are processed to a standard flow intended
to meet the cost and shorter lead-time needs of large volume
satellite manufacturers, while maintaining a high level of
reliability. Features The Intersil HS-26C32RH-T is a Quad Differential Line
Receiver designed for digital data transmission over
balanced lines and meets the requirements of EIA Standard
RS-422. Radiation Hardened CMOS processing assures low
power consumption, high speed, and reliable operation in
the most severe radiation environments. EIA RS-422 Compatible Inputs The HS-26C32RH-T has an input sensitivity of 200mV (typ).
over the common mode input voltage range of п‚±7V. The
receivers are also equipped with input fail safe circuitry,
which causes the outputs to go to a logic “1” when the inputs
are open. Enable and Disable functions are common to all
four receivers. QML Class T, Per MIL-PRF-38535 Radiation Performance
-Gamma Dose 1 x 105 RAD(Si)
-SEU and SEL Immune to 100MeV/mg/cm2 CMOS Compatible Enable Inputs Input Fail Safe Circuitry High Impedance Inputs when Disabled or Powered Down Low Power Dissipation 138mW Standby (Max) Single 5V Supply Full -55В°C to +125В°C Military Temperature Range Applications Line Receiver for MIL-STD-1553 Serial Data Bus Specifications Functional Diagram Specifications for Rad Hard QML devices are controlled by
the Defense Supply Center in Columbus (DSCC). The SMD …

DATASHEET
HS-26C32RH, HS-26C32EH FN3402
Rev 5.00
May 28, 2013 Radiation Hardened Quad Differential Line Receiver
The Intersil HS-26C32RH, HS-26C32EH are differential line
receivers designed for digital data transmission over balanced
lines and meets the requirements of EIA Standard RS-422.
Radiation hardened CMOS processing assures low power
consumption, high speed, and reliable operation in the most
severe radiation environments.
The HS-26C32RH, HS-26C32EH have an input sensitivity
typically of 200mV over the common mode input voltage
range of п‚±7V. The receivers are also equipped with input fail
safe circuitry, which causes the outputs to go to a logic “1”
when the inputs are open. Enable and Disable functions are
common to all four receivers.
Specifications for Rad Hard QML devices are controlled by the
Defense Logistics Agency Land and Maritime (DLA). The SMD
numbers listed in the “Ordering Information” table must be
used when ordering.
Detailed Electrical Specifications for these devices are
contained in SMD 5962-95689. A “hot-link” is provided on our
homepage for downloading Features Electrically screened to SMD #5962-95689 QML qualified per MIL-PRF-38535 requirements 1.2 micron radiation hardened CMOS …