Datasheet Texas Instruments UC37133D — Ficha de datos

UC17131/2/3
UC27131/2/3
UC37131/2/3 Smart Power Switch
FEATURES DESCRIPTION 300mA Continuous Output Current The UC37131, UC37132 and UC37133 are a family of smart power
switches which can drive resistive or inductive loads from the high side or
low side. Low Side or High Side Switch
Configuration 8V to 65V Operation Overload and Short Circuit Protection Power Interruption Protection +6V Regulated Voltage 2mA Quiescent Current Programmable Overcurrent and
Power Interruption Protection The UC37132 is available in 14 pin (DIP), 16 pin (SOIC), or 20 pin (CLCC)
packages and can accommodate both low side (load to VCC) or high side
(load to GND) configurations. The UC37131 and UC37133 are exclusively
for a low side or a high side configuration respectively and both are available in an 8 pin package. Both high side and low side configurations provide
high current switching with low saturation voltages which can drive resistive
or inductive loads.
The input to the switch is driven by a low voltage signal, typically 5V. Additionally, UC37132 features adjustable hysteresis. The output of the device
can switch a load between 8V and 65V. Output current capability is 300mA
continuous or 700mA peak. 1% to 30% Programmable Input
Comparator Hysteresis (on UC37132) The device also has inherent smart features that allow for programmable
turn-on delay in enabling the output following startup. The same capacitor Low and High Side Internal High
that specifies the turn-on delay is also used to program a VCC power interCurrent Clamps When Driving
ruption time. If VCC drops below a threshold for a time specified by this caInductive Loads
pacitor, the output is turned off and a new turn-on delay will be re-triggered.
Similarly, if high current persists longer than the response delay, the output
driver will operate in a very low duty cycle mode to protect the IC. UC37132 BLOCK DIAGRAM VREF 6V …